mlabel(1)							     mlabel(1)



Name
       mlabel - make an MSDOS volume label



Note of warning
       This  manpage  has  been  automatically generated from mtoolss texinfo
       documentation, and may not be entirely accurate or complete.   See  the
       end of this man page for details.


Description
       The mlabel command adds a volume label to a disk. Its syntax is:
       mlabel [-vcsn] [-N serial] drive:[new_label]


       Mlabel  displays  the current volume label, if present. If new_label is
       not given, and if neither the c nor the s options are set,  it  prompts
       the  user  for a new volume label.  To delete an existing volume label,
       press return at the prompt.

       Reasonable care is taken to create a valid MS-DOS volume label.	If  an
       invalid	label is specified, mlabel changes the label (and displays the
       new label if the verbose mode is set). Mlabel returns 0 on success or 1
       on failure.

       Mlabel supports the following options:

       c      Clears an existing label, without prompting the user

       s      Shows the existing label, without prompting the user.

       n      Assigns a new (random) serial number to the disk

       N serial
	      Sets  the  supplied  serial  number. The serial number should be
	      supplied as an 8 digit hexadecimal number, without spaces


See Also
       Mtools texinfo doc

Viewing the texi doc
       This manpage has been automatically  generated  from  mtoolss  texinfo
       documentation.  However,  this  process is only approximative, and some
       items, such as crossreferences, footnotes and indices are lost in  this
       translation process.  Indeed, these items have no appropriate represen
       tation in the manpage format.  Moreover, not all information  has  been
       translated into the manpage version.  Thus I strongly advise you to use
       the original texinfo doc.  See the end of this manpage for instructions
       how to view the texinfo doc.

       *      To  generate a printable copy from the texinfo doc, run the fol
	      lowing commands:

		     ./configure; make dvi; dvips mtools.dvi



       *      To generate a html copy,	run:

		     ./configure; make html

	      A premade html can be  found  at:  http://mtools.linux.lu  and
	      also at: http://www.tux.org/pub/knaff/mtools

       *      To  generate  an	info  copy (browsable using emacs info mode),
	      run:

		     ./configure; make info



       The texinfo doc looks most pretty when printed or as html.  Indeed,  in
       the  info  version  certain  examples  are difficult to read due to the
       quoting conventions used in info.




mtools-3.9.10			    28Feb05			     mlabel(1)